Flex cable is an important component in RC boats, and its lifespan can vary depending on a number of factors. In general, however, you can expect flex cable to last for several years with proper care and maintenance. With that…
The Felion Rc Boat is a remote control boat that can be used in pools or ponds. It is a great toy for children and adults alike. If you need to disassemble the Felion Rc Boat, follow these steps: 1.…
There are a few different ways that you can waterproof your RC boat hull. You can use a sealant, paint, or even a clear wrap. Each option has its own advantages and disadvantages, so it’s important to choose the right…
To waterproof wood RC boat, you need to purchase a waterproofing sealant from your local hardware store. Follow the instructions on the can and apply it to your boat. Make sure you coat all sides of the wood and pay…
Assuming you have a Walbro carburetor and gas tank, and you want to know how to connect them: First, make sure the carburetor is turned off. Next, locate the fuel inlet on the side of the carburetor. This is where…
Turn on the transmitter by pressing and holding the power button for two seconds. The green LED should light up, indicating that the transmitter is on. Connect the battery to the ESC (electronic speed controller) using the provided battery connector.…
If you’re looking to waterproof your RC boat motor, there are a few things you can do. First, make sure that the motor is properly sealed. This can be done by using silicone sealant or another type of waterproofing sealant.…
To detounge a RC boat prop, you’ll need to remove the propeller and inspect it for any debris or damage. If there is debris caught in the blades, use a toothpick or other small tool to gently remove it. Inspect…
Before painting your fiberglass RC boat, you will need to clean and sand the surface. Once the surface is prepped, you can then apply a primer and paint of your choice. For best results, use multiple thin coats of paint…
To replace the clutch bell on your Enforcer RC Boat, first remove the four screws that hold the bell housing onto the boat. Next, remove the propeller shaft by unscrewing it from the motor. Be careful not to lose any…