To replace the clutch bell on your Enforcer RC Boat, first remove the four screws that hold the bell housing onto the boat. Next, remove the propeller shaft by unscrewing it from the motor. Be careful not to lose any…

There are a few things to keep in mind when soldering RC boat flex cable. First, be sure to use the correct type of solder. Second, make sure the area to be soldered is clean and free of any dirt…

There are a few things you need to do in order to run your RC boat with brush motors. First, make sure that the batteries are properly charged and installed. Next, connect the ESC (electronic speed control) to the brushless…

Brushless motors are not only more powerful, but also have longer lifespans than brushed motors. When choosing a brushless motor for your RC boat, keep in mind the following factors: Kv rating, max current, max voltage, and weight. You will…

Use silicone caulk to seal the battery box on your RC boat. First, clean the area around the box with alcohol to remove any dirt or grease. Next, apply a bead of caulk around the lid of the box. Then,…

Assuming you would like tips on how to trim your RC boat: 1. Check that the boat is level from front to back and side to side. This can be done by eye or with a leveling device such as…

To tune up a RC gas powered boat, you will need to purchase a tuning kit specific to your model of boat. Once you have the kit, follow the instructions included with it to properly adjust the carburetor and ignition…

If you’re thinking about getting into nitro RC boats, there are a few things you need to know before you get started. Here’s a quick rundown of what you need to get started in the exciting world of nitro RC…

1. Read the user manual before operating the boat. 2. Familiarize yourself with all of the controls and how they work. 3. Choose a calm body of water to use the boat in. Avoid areas with strong currents or high…